
This project was undertaken by Drascombe Nederland in winter 2025. The owner and boat are based in Amsterdam and for sometime the boat had been taking in water, however matters were getting worse and at one stage it had to be boarded and a large pump was used to bail it out. Action now was urgently required to resolve the issue.



With such a large amount of water getting in it pointed to the centre plate pin which is a common problem. How many times have I seen a rusted pivot pin like this? It’s totally eaten with rust and decay and on closer inspection it has enlarged the holes in the 2 side cheeks of the centre plate casing. It’s necessary to cut an access slot in the outside casing in order to tackle this problem. The holes are severely enlarged and oval.
With this panel cut one can see the extent of the wear that has taken place. The hole should have been 10 mm, it’s now 28 mm. It’s no wonder such an amount of water was getting in it!


This shot shows the position of the access hatch required. Here too is the JLJ centreplate strengthening plates and Stainless Steel pivot pin kit, which Michel at Drascombe Nederland holds in stock. They not only have a new pin but the 2 plates sit on the keel line of the boat and take all the weight of the pin. The holes in the plates at 52 mm centres correspond with the original centres of the pins.
Firstly the entire area either side of the holes have to be thoroughly cleaned and abraded to remove any contamination.


Both faces have to be prepped and ‘glassed over with glass fibre mat’ before applying the strengthening plates. The area completed with the plates is now glassed in position.


With the new hole drilled for the pivot pin, we need to fit the plates with washers and seals either side. A great job done on the pivot pin, which is such a common problem with these early to mid 1990 boats sadly. Just very poor manufacturing and the use of mild steel vulnerable to corrosion instead of A4 stainless steel.


Moving on, whist waiting for the hull to dry out to glass the pivot pin, there were other quite urgent tasks to undertake. Firstly, the main sheet traveller side deck housings has deteriorated badly. These had to be repaired and strengthened to take the new JLJ stainless tube.



So, the tube now fitted and such an improvement, with a new Mizen mast / rudder step fitted along with one of our JLJ laminated engine boards. Such a great improvement to an aged boat.
Another great job leaves the yard of Drascombe Nederland at Huizen.
