• Skip to primary navigation
  • Skip to main content
Just Lugger Joinery

Just Lugger Joinery

  • Home
  • Products
    • Joinery
    • Spars
    • Accessories
  • How to Do It
  • Client Stories
  • Workshop Courses
  • Phil’s Workshop Blog
  • Ordering

It’s making time again to build up and refresh the joinery stock

The Mizen mast Thwart/ rudder step is a joinery piece that I have re-engineered from the original design and to give it more strength at the aft section of the mast slot. The old design was so weak at this point and the brass / copper rivet that was driven through then planished over at each end was a disaster waiting to happen.

A Mizen mast thwart/ rudder step with its bag of stainless steel machine screws ready to pack and place into stock

The improvement I have made is to increase by 30 mm the back edge of the slot that secures the mast. This was a weak point and didn’t take much for the mast to split the shoulder.

I dispensed with the soft brass / copper rivet many years ago and now use a 5 mm threaded studding with domed nuts on either end. These can be tightened as the timber dries out.

I’m sure you will note from these joinery pieces that there are several different processes involved in their manufacture. To make a single piece one is constantly changing machine tooling to perform each different operation, so to make this process viable in time and for you the customer viable in terms of the finished cost, I have to make at least 15 pieces at a time, so maximising on each process and keeping the finished cost acceptable.

With a new stock of Iroko I’m able to select which boards to split and then cut to length to give me as little wastage as possible. Having done this I then plane and thickness all these pieces in one operation to a stage where each piece is of equal thickness, the same length and width. Then starts the machining process. Once each piece is placed on the machining jig, all processes can be done without having to move it.

Pieces ready to place on the jig

With just 2 initial guide holes drilled I’m able to use the router to follow the jig / former, which is underneath, to machine out the mast slot and the rudder slot. The radiusing of the edges and the chamfers that are applied to inside edges are all done on the jig.

With all of these machine processes complete, it means that there is total accuracy, there is no guess work and each piece is produced very efficiently. For you the customer this is important, it’s cost effective and for JLJ it means I’m able to manufacture a good stock level in one hit. Repetitive manufacturing is the method which is most cost and material efficient.

Copyright © 2026 Dragon Design · Contact Details · Terms & Conditions · Materials · About Us